Quote:
Originally Posted by ikheetleon
Quote:
Originally Posted by JonM
I had the same issue with the passenger side. There isn’t enough space. My solution, which wasn’t mentioned in the excellent PDF provided by R33, was to leave the 2 T20 silver screws out of the new bracket (comes with the knee pad part). This way the bracket can float a little. Dock the metal locking tab into the center console completely. Then drive home the 2 silver T20 screws from the passenger side. This will help greatly. This is a slight deviation from the PDF.
|
Ok, so just fasten the bracket with the one black screw near the dash and leave the others skrews out? So install the bracket apart from the pad. I'll give it a try, but am affraid the dash will still be in the way. Is there a way to remove the dash panel between the glove compartment and center console?
|
Use a bit of leather cleaner to lubricate part into place. If you separate the base from the pad you are not going to be able to put the pad on again.