|
Sorry if I'm asking the obvious but you did change the sensors with the pads? If you didn't and you were below 50% that could be your isssue.
No special diagnostics required to reset, just full ignition on the push and hold the trip reset button and after maybe 10 seconds a reset for the first cbs item due should come up saying reset possible, then either push it again to move on to the next cbs item or press and hold until it says reset in progress then let go no you should get a reset successful message. If you've done all this try it again with the handbrake off, I know it sounds weird but it helps sometimes. Below the steps in an easy read format.
Ignition on
Press and hold trip button - first service due shows up
Release trip button
To reset the current item:
Press and hold - reset possible shows up
Release
press and hold - reset in progress shows up
Release - reset susccessful shows up after a few seconds
To move on to next item say you want to reset pads but brake fluid is before it:
Press and release until shows correct item
Hope that makes sense it does in my head, sorry if you've tried all this but maybe useful to someone
|