Quote:
Originally Posted by crystalworks
When I used my NT530 it froze up during the bleed procedure and ran the pump for a long time, don't remember how long, but long enough that I was concerned.
|
Funny you mention that....I think I read your post prior to doing the work and was bummed to read that NT530 might not be up to the challenge.
Before heading out to the garage, I did a quick software check and there was an update. I can't swear by it, but I recall reading a release note that Foxwell updated the diesel fuel pump primer option.
When I executed the prime command, I was prepared to let it run for several minutes. The pump whirred to life for about 20-30 seconds and I heard gurgling and bubbling equal to that of turning on main water line in a house. While happy the NT530 didn't freeze, I assumed it didn't run to full completion and just moved on.
I then crossed my fingers and it started right up without any hiccups.
