Quote:
Originally Posted by Clifton
System Bleeding:- The internet says it's not required, but I opted to do it yielding a fast crank and no fault codes
- The Foxwell NT530 scan tool with latest software will bleed the system
- You do not need to bleed with the system open (fuel line/filter separated)
- Make sure you have more than a 1/4 tank to use scan tool to bleed or no bleed for you! Apparently you need 20Ls.
|
Good tips.
When I used my NT530 it froze up during the bleed procedure and ran the pump for a long time, don't remember how long, but long enough that I was concerned. X5 wouldn't fire up after disconnecting the Foxwell. So I cycled the ignition once and then it fired up after a long crank. No problems since then. I'll check and see if my Foxwell is on the latest revision of the software...