Quote:
Originally Posted by r33_RGSport
@Rotzy , seems correct installation.
I was just want to make sure. Because the installation between RC and BMS are total opposite.
BMS uses MAF sensors, while RC uses TMAP sensors.
|
I put 100 miles on it today, mostly highway, mostly normal (ie. sedate) driving. While on the highway, EcoPro mode, cruise control set and climbing a large bridge, I received the dreaded Drivetrain Malfunction. Engine would barely idle, was shaking like crazy and it was only drivable in very low gear/high rpm settings. Anything else would shake your teeth out. I pulled over, shut it down and pulled the codes below. After resetting them, it ran fine the rest of the morning (an additional 30 miles).
I think I remember some people experiencing the drivetrain malfunction when selecting higher S2 settings, but I'm only running at C.
Thoughts?