Quote:
Originally Posted by djsaad1
So after a few months, I finally had some time to look at the x5 coding again. Here is a better clarification for the last drive modes.
If you go into the ICM module then the 300A DSC ICM CODIERDATEN folder. Towards the middle you will see a few feshasmode codes.
Mode 1 = Comfort
Mode 2 = Comfort +
Mode 3 = not sure
Mode 4 = Sport
Mode 5 = Sport+
Mode 6 = Don't know yet
Mode 7 = Eco Pro
Mode 8 = Edrive (not relevant)
You can turn any of these on (even though most are on by default) by activating the corresponding feshasmode code. For example, to turn on comfort+, you would change feshasmode2 to active.
Below these codes you will find a few fesallowmodelastfunction codes. If you turn these on, the car will remember the last setting it was in when you turned it off, and will then turn on in the same setting. You can turn on more than one at a time.
So fesallowmode2lastfunction will remember comfort+ mode, fesallowmode4lastfunction will remember sport mode, and fesallowmode7lastfuncion will remember eco pro.
The last thing you will need to do to get the car to not reset the last driving mode is change the werte in feslastfunctioninterval to FF.
P.S. for those of you that don't have sport+ on your car, you should try just turning on feshasmode3 and see if that solves the issue.
|
Hmm that's interesting! Do you know if this allows to have a 40 Edrive start up in max E-drive mode instead of auto E-drive?