11-24-2016, 06:08 PM | #1 |
New Member
5
Rep 14
Posts |
Traffic Jam Assist cannot be activated
Hi All
Just done the retrofit on my f15 50i changed new steering wheel wiring harnesses and extra touch sensor module also the buttons, but after the VO and FDL coding it shows TJA failure on the dash, code HOD_HAUBER to inactive the failure message is disappeared but it shows TJA cannot be activated, so is there any coding I missed please help. Thanks |
11-25-2016, 12:16 AM | #2 |
Major General
2374
Rep 8,364
Posts |
Did you do everything listed in Google Doc (Line 146-164)?
|
Appreciate
0
|
11-25-2016, 04:51 AM | #3 | |
New Member
5
Rep 14
Posts |
Quote:
|
|
Appreciate
0
|
12-19-2016, 08:31 PM | #10 |
Self-Deprecating Narcissist
7266
Rep 6,561
Posts |
Is there a "kit" one could purchase to retrofit or do I have to source all the parts individually?
If I am going to keep this car a few more months I want to have some more fun with it.
__________________
|
Appreciate
0
|
04-16-2018, 05:40 AM | #11 | |
Registered
0
Rep 2
Posts |
Quote:
|
|
Appreciate
0
|
10-03-2018, 11:16 PM | #12 |
New Member
7
Rep 24
Posts |
Sorry, I'm just seeing this. I hope you figured it out!
I believe you were at the point where you needed to switch to BMW's Diagnostic software called Rheingold - It diagnoses the car, realizes the steering wheel's touch sensor is new and needs to be calibrated, you have it run through its procedure, and then it should work. I don't recall if ISTA+ is the same as Rheingold, sorry |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|