Regarding M Performance Front Lip

[brandonsim]

Hi guys,

For those who have the M performance carbon front lip on using betalink K2, do you guys have this issue whereby both corner has a bit of gap like that? Refer to photo below:

[sbinshihon]

Yes, I have that problem.

I think you should have pushed the lip with you hands until the Betalink dries and hold a strong bond.

[HomeIn2]

That gap shouldn’t be there and the edges should be tight and flush. The trick it to push it flush and tape it up prior to the Betalink fully solidifying.

[brandonsim]

Originally Posted by sbinshihon

Yes, I have that problem.

I think you should have pushed the lip with you hands until the Betalink dries and hold a strong bond.

So did you do the same with yours? I think the installer tape too much on the front and forgot about the side before the k2 solidify. They will try to redo it again tomorrow

[teodorjelev]

this is my third spoiler

[brandonsim]

Too much tape?

[brandonsim]

Originally Posted by teodorjelev

this is my third spoiler

thanks for sharing those close-up photos, i will share it to my installer tomorrow