Remapping F16 X6 40d

[UltimateManga]

I'm thinking about remapping my X6 40d by a good reputable company but my main concern is about possible problems that may occur!

Figures are to 376bhp from 308, 730nm from 630 and 530 lbs of torque from 465.

I had a 335d done many years ago which was amazing after the remap and luckily had no problems at all within the 3 years of ownership, but just abit cautious about maybe possible strain on the turbos and gearbox which will invalidate the warranty if anything goes wrong.

Any help and thoughts on this will be much appreciated guys so thanks in advance

[MattBianco]

Originally Posted by UltimateManga

I'm thinking about remapping my X6 40d by a good reputable company but my main concern is about possible problems that may occur!

Figures are to 376bhp from 308, 730nm from 630 and 530 lbs of torque from 465.

I had a 335d done many years ago which was amazing after the remap and luckily had no problems at all within the 3 years of ownership, but just abit cautious about maybe possible strain on the turbos and gearbox which will invalidate the warranty if anything goes wrong.

Any help and thoughts on this will be much appreciated guys so thanks in advance

Look at the Belgium based company in my piggy back chip comparison, located in my signature/footnote section of this message. They contacted me shortly after the comparison post went front page on this site, and they claimed to have been the company behind unlocking the Bosch mapping. They have a mapping service as well as chips. Some of the others on the comparisons chart also remap, but I am not sure which.