01-08-2024, 03:02 PM | #1 |
Private
7
Rep 76
Posts |
E-Sys Cannot Flash ZBE4
I’ve successfully (almost) flashed our new F15 with the latest psdzdsta except for the ZBE4 module which refuses to play ball.
I’ve got the following error message but not sure why. It’s not a retrofit or a replacement unit. The module appears when I Read (ECU) but interestingly doesn’t appear in ISTA+ (not sure if it should?). TAL execution started. ExecutionID=2024/01/08-15:27:10.878 [] prepareTALExecution started [PROGRESS] [] prepareTALExecution finished [PROGRESS] [] prepareVehicleForFlash started [PROGRESS] [] prepareVehicleForFlash finished [PROGRESS] [ZBE4 - 67] ECUId:ZBE4_0x67 not accessible cause no distinct gateway could be determined from ODX data and installedEcuList. Please check if installedEcuList in TAL is complete and correct project is used. Possible gateways are: [ECUId:ZGW2_0x10, ECUId:BDC_GW2_0x10, ECUId:FEM_GW_0x10, ECUId:INGA18_GW_0x10, ECUId:ZGW_0x10] [THROWABLE] [] finalizeVehicleFlash started [PROGRESS] [] finalizeVehicleFlash finished [PROGRESS] [] prepareVehicleForCoding started [PROGRESS] [] prepareVehicleForCoding finished [PROGRESS] [] finalizeVehicleCoding started [PROGRESS] [] finalizeVehicleCoding finished [PROGRESS] [] finalizeTALExecution started [PROGRESS] [] finalizeTALExecution finished [PROGRESS] TAL execution finished [TAL_EXECUTION_FINISHED] TAL-Execution finished with status: "FinishedWithError". [C207] TAL execution finished. Duration: "37s". [C206] Read SVT after TAL execution started. Read SVT after TAL execution finished. Any ideas? It’s not a massive deal but I’d like to have all of the modules updated. I’ve got TeamViewer of that helps. Thanks in advance. Matt |
Post Reply |
Bookmarks |
|
|