Quote:
Originally Posted by letsgosabres
excellent write up thanks. I was successful with replacing the filter but I do not have the ISTA/D and therefore couldn't prime the system. My vehicle started right up after the new filter was installed but it only ran for 30 seconds then shut down. Now it won't start at all and the check engine light is on. I just ordered a foxwell scanner to find out what the erroe code is. Do you know where I can get this software and any cables necessary to hook up my laptop? I should have been more prepared before I started this project but that's a moot point now.
|
Try cycling the start/stop button 2-3 times without press the brakes while pausing 20 seconds in between with each cycle. Then try to start the vehicle, if it runs rev it up to 1500-2000 rpm for about 30 sec. If it doesn’t start do not reattempt your running a risk of running your pump dry and can cause damage.