Quote:
Originally Posted by Littlebear
"My Noctua CPU cooler wants me to torque it onto my CPU at 0.6 Nm. I don't own that torque wrench!
~ 5.3 inch/lb
~ .44 ft/lb
How would you all go about this, pls?"
|
Hang a one pound weight on the handle of your wrench, exactly 5.3 inches from the center of the screw?
Lacking either tool, my go-to rule for fasteners is to tighten them enough so they don't fall out...but not so tight that they will never come out again.
I don't have a micro-torque wrench handy, but would go with fingertips only on a large diameter screwdriver handle as a safe substitution. Of course, I need to point out that my aged hands bought the computer pre-assembled with the i9 processor....