Chassis Stabilization: Drive moderately - Error message

[mig25]

Originally Posted by Tannaciousz

Here are the two messages I get on mine. Pretty frustrating because the truck drives completely fine, other than these annoying warning lights.

These are the very same messages I am getting after replacing the filter and refilling the transmission, I did take all the steps to refill it running after it warmed up.
Code I am getting is FF480A

[Tannaciousz]

Got mine fixed on Friday. Took it to the Indy shop that changed the auxiliary battery out last week, TMJ Bimmer in Northwest Houston, and they scanned it, and determined the culprit to be the right rear wheel speed sensor. Every time the Chassis Stabilization Error and Parking Brake Reduced Error were triggered, it was after the wheel speed sensor caused a fault. So, $379.00 later for diagnostic, parts and labor and a couple hours waiting to get the part from BMW, no more issues so far.

[mig25]

I fixed this issue YEAY!!!

The problem was ABS speed sensor. I change both from the rear. Reset by disconnecting the battery. Issue resolved. No more messages or warning lights.

[chihming]

Originally Posted by mig25

I fixed this issue YEAY!!!

The problem was ABS speed sensor. I change both from the rear. Reset by disconnecting the battery. Issue resolved. No more messages or warning lights.

Is there a detailed process?：弓：

[Vivek.]

Originally Posted by chihming

Is there a detailed process?：弓：

Take off the wheel, locate the ABS speed sensor:



Remove and replace; one end is held on with a ~5mm allen and the other end unplugs from the connector.

[b.frank70]

Originally Posted by Tannaciousz

Got mine fixed on Friday. Took it to the Indy shop that changed the auxiliary battery out last week, TMJ Bimmer in Northwest Houston, and they scanned it, and determined the culprit to be the right rear wheel speed sensor. Every time the Chassis Stabilization Error and Parking Brake Reduced Error were triggered, it was after the wheel speed sensor caused a fault. So, $379.00 later for diagnostic, parts and labor and a couple hours waiting to get the part from BMW, no more issues so far.

I got this error tonight. Will have to wait until Monday to take it into the shop

[mechatony11]

I apologize for bringing up this old thread. I had a similar issue with my 2015 BMW 320, it turns out that I had a ball joint issue, I heard a rattling noise while I’m driving the other day then the error code popped up. I took it to the shop so I can replace it immediately because it affects my driving and control of the car. I did a lot of searches on this issue and came on in depth article which may be worth reading, search for " BMW chassis stabilization malfunction drive moderately on YOUCANIC" and you will see an article that goes over common causes and possible fixes, you can read about it yourself. I hope this information can assist someone else with a similar issue.